Installation Procedure
WARNING: This page is about a different car, the 2016 Chevrolet Trax and 2016 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
- Position the stabilizer shaft (1) on the drivetrain and front suspension frame.
- Front Stabilizer Shaft Insulator Clamp Bolt (2) - Install
- Front Stabilizer Shaft Insulator Clamp Nut (1) - Install and tighten 22 N.m (16 lb ft)
- Raise the rear of the drivetrain and front suspension frame.
- Install ALL drivetrain and front suspension frame bolts. Drivetrain and Front Suspension Frame Replacement (Long Cradle)Drivetrain and Front Suspension Frame Replacement (Short Cradle)Drivetrain and Front Suspension Frame Replacement (Long Cradle - V5O)
- Remove the adjustable stands from underneath the vehicle.
- Exhaust Isolator@Drivetrain and Front Suspension Frame - Install - Exhaust Front Pipe Replacement (LUV)Exhaust Front Pipe Replacement (LE2)
- Front Lower Control Arm@Steering Knuckle - Install - Lower Control Arm Replacement
- Front Stabilizer Shaft Link@Front Stabilizer Shaft - Install - Stabilizer Shaft Link Replacement
- Steering Linkage Outer Tie Rod@Steering Knuckle - Install - Steering Linkage Outer Tie Rod Replacement
- Front Wheelhouse Liner-Left Side - Install - Front Wheelhouse Liner Replacement (Trax)Front Wheelhouse Liner Replacement (Encore)
- Drivetrain and Front Suspension Frame Transmission Protector - Install - Drivetrain and Front Suspension Frame Transmission Protector Replacement
- Install the front tire and wheel assemblies. Tire and Wheel Removal and Installation
- Intermediate Steering Shaft@Steering Gear - Install - Intermediate Steering Shaft Replacement (NJ1)Intermediate Steering Shaft Replacement (N40)
- Measure and adjust the wheel alignment. Wheel Alignment - Steering Wheel Angle and/or Front Toe Adjustment
NOTE:
Start ALL fasteners by hand before tightening.
CAUTION:
Refer to Fastener Caution .