LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2014 >> Trax LT, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 42 (Front Suspension System) >> Repair Instructions >> Wheel Stud Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2013 Chevrolet Trax and 2013 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Wheel Hub Flange, Lug Nut And Washers
    GM2327497Courtesy of GENERAL MOTORS COMPANY
  1. Install a NEW wheel stud in the front wheel bearing and hub assembly flange (2).
  2. Position flat washers (3) and an old wheel nut (1) on the wheel stud.
  3. Use a pry bar to prevent the front wheel bearing and hub assembly flange from turning.
  4. Tighten the wheel nut until the wheel stud is firmly seated in the front wheel bearing and hub assembly flange.
  5. Remove the wheel nut and the flat washers.
  6. Install the front wheel bearing and hub assembly. Refer to Front Wheel Bearing and Hub Replacement .
  7. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
scientia non olet · About LEMON Manuals