Installation Procedure
WARNING: This page is about a different car, the 2013 Chevrolet Trax and 2013 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
- Install the generator (1).
- Install the 2 generator fasteners (2) and tighten to 35 N.m (26 lb ft).
- Install the battery positive cable (3) and tighten the fastener (1) to 17 N.m (13 lb ft).
- Connect the engine wiring harness connector (2).
- Install the right front wheel drive shaft. Refer to Front Wheel Drive Shaft Replacement - Right Side .
- Install the drive belt. Refer to Drive Belt Replacement .
- Connect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection .
CAUTION:
Refer to Fastener Caution .