LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2014 >> Trax LS, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 53 (Object Detection System And Pedestrian Protection System) >> Diagnostic Information and Procedures >> DTC B0958, B0959, B0960, or B0961 >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different car, the 2013 Chevrolet Trax and 2013 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition ON.
  2. Verify that DTC B1405 is not set.
    • If the DTC is not set 
  3. Verify that DTC B0958 01, B0959 01, B0960 01, B0961 01, B0958 21, B0959 21, B0960 21 or B0961 21 is not set.
    • If the DTC is set 
    1. Verify the B78 Rear Object Sensors are not contaminated with snow, mud, dirt, slush, or ice.
      • If contaminated, clean sensor.
      • If there is no contamination
    2. Refer to Circuit/System Testing below.
    • If the DTC is not set 
  4. Verify that DTC B0958 3A, B0959 3A, B0960 3A or B0961 3A is not set.
    • If the DTC is set 

      Replace the B78 Rear Object Sensor with the correct sensor type.

    • If the DTC is not set 
  5. Ignition ON, transmission in REVERSE.
  6. Verify the scan tool Parking Assist System Status parameter displays Enabled.
    • If the Parking Assist System displays Disabled 

      Refer to Circuit/System Testing below.

    • If the Parking Assist System displays Enabled 
  7. All OK.
scientia non olet · About LEMON Manuals