Steering Gear Boot Replacement

WARNING: This page is about a different car, the 2013 Chevrolet Trax and 2013 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Steering Gear Boot

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedures Remove the steering gear. Refer to Steering Gear Replacement (N40) or Steering Gear Replacement (NJ1) . Remove the steering linkage outer tie rod. Refer to Steering Linkage Outer Tie Rod Replacement .
1	Steering Linkage Inner Tie Rod Nut CAUTION: Refer to Fastener Caution . NOTE: Mark the position of the steering linkage inner tie rod nut before removing to aid in installation.
2	Steering Gear Boot Outer Clamp
3	Steering Gear Boot Inner Clamp Procedure Cut the steering gear boot inner clamp. Discard the clamp. Use the CH-804 plier to install a NEW steering gear boot inner clamp. Special Tools CH-804 Boot Clamp Plier For equivalent regional tools, refer to Special Tools .
4	Steering Gear Boot Procedure Inspect the steering linkage inner tie rod for evidence of corrosion or contamination. If none is evident, continue with the repair. If corrosion or contamination is evident, replace the steering gear. Refer to Steering Gear Replacement (N40) or Steering Gear Replacement (NJ1) . Install the steering gear boot and ensure the boot is seated in the assembly groove of the steering gear before installing the steering gear boot clamps.