Installation Procedure
- Install the fuel sender assembly. Refer to Fuel Sender Assembly Replacement (AWD) .
- Transfer the fuel tank fuel pump module. Refer to Fuel Tank Fuel Pump Module Replacement (AWD) .
- Transfer the evaporative emission canister. Refer to Evaporative Emission Canister Replacement (AWD) .
- Install the fuel tank to the hydraulic lift.
- With the aid of an assistant, position the fuel tank to the vehicle.
- Install both fuel tank straps to the fuel tank (2) and tighten the fasteners to 22 (16 lb ft).
- Remove the hydraulic lift from the fuel tank.
- Connect the EVAP system hoses. Refer to Evaporative Emission System Hose/Pipe Replacement (Fuel Pump Module to Canister AWD) Evaporative Emission System Hose/Pipe Replacement (Canister to Pipe AWD) .
- Connect the fuel feed pipe. Refer to Fuel Feed Pipe Replacement (At Tank AWD) .
- Connect the fuel tank filler pipe. Refer to Fuel Tank Filler Pipe Replacement .
- Connect the fuel tank fuel pump module wiring harness (1) and clip the fuel tank module wiring harness to the chassis.
- Install the propeller shaft. Refer to Two-Piece Propeller Shaft Replacement .
- Install the exhaust. Refer to Exhaust Muffler Replacement (LUV) ,.
- Install the right rear wheelhouse panel liner. Refer to Rear Wheelhouse Liner Replacement .
- Lower the vehicle.
CAUTION:
Refer to Fastener Caution .