Installation Procedure

Install the window to the door with the regulator adjusted to the remove/load position.

Fig 1: Locating Front Side Door Window & Regulator Bolts
Courtesy of GENERAL MOTORS COMPANY
Tilt the window forward and carefully guide the window into the rear run channel.
Position the window (1) to an upright position.
Loosely tighten the regulator bolts (2).
Carefully move the regulator upward for short slow intervals, while ensuring that the window remains in the run channels.
NOTE: Do not operate the regulator motor without supporting the window. Ensure that the window remains in the run channels when operating the regulator motor.
Position the window (1) to a fully secure position into the upper door weatherstrip.
Tighten the 2 regulator bolts (2).
CAUTION: Refer to Fastener Caution .

Tighten

Tighten the bolts to 10 N.m (89 lb in).
Lower the window to the full down position.
Install the inner belt sealing strip. Refer to Front Side Door Window Belt Inner Sealing Strip Replacement .
Install the water deflector. Refer to Front Side Door Water Deflector Replacement .
Install the door trim panel. Refer to Front Side Door Trim Panel Replacement - Left Side (Acadia or Traverse) , Front Side Door Trim Panel Replacement - Left Side (Enclave) or Front Side Door Trim Panel Replacement - Right Side (Enclave) , Front Side Door Trim Panel Replacement - Right Side (Acadia or Traverse) .