LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2014 >> Traverse LS, 4D Utility >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine Controls And Fuel - 3.6L (LLT) - Repair Instructions >> Repair Instructions >> Knock Sensor Replacement - Bank 2 >> Removal Procedure

Removal Procedure

  1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
    Fig 1: Identifying Engine Wiring Harness Electrical Connector
    GM1860484Courtesy of GENERAL MOTORS COMPANY
  2. Remove the engine oil filter. Refer to Engine Oil and Oil Filter Replacement .
  3. Lower the vehicle.
  4. Disconnect the engine wiring harness electrical connector (2) from the bank 2 knock sensor (3).
  5. Loosen the knock sensor bolt and remove the knock sensor.
    Fig 2: View Of Left Knock Sensor
    GM860802Courtesy of GENERAL MOTORS COMPANY
scientia non olet · About LEMON Manuals