LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2014 >> Traverse LS, 4D Utility >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine Controls And Fuel - 3.6L (LLT) - Repair Instructions >> Repair Instructions >> Knock Sensor Replacement - Bank 1 >> Removal Procedure

Removal Procedure

  1. Remove the exhaust manifold lower heat shield. Refer to Exhaust Manifold Lower Heat Shield Replacement .
    Fig 1: Identifying Knock Sensor & Crankshaft Position (CKP) Sensor Electrical Connectors
    GM1860405Courtesy of GENERAL MOTORS COMPANY
  2. Disconnect the engine wiring harness electrical connector (1) from the bank 1 knock sensor (2).
  3. Loosen the knock sensor bolt and remove the knock sensor.
    Fig 2: View Of Right Knock Sensor & Bolt
    GM860801Courtesy of GENERAL MOTORS COMPANY
scientia non olet · About LEMON Manuals