LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2014 >> Traverse LS, 4D Utility >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine Controls And Fuel - 3.6L (LLT) - Repair Instructions >> Repair Instructions >> Knock Sensor Replacement - Bank 1 >> Installation Procedure

Installation Procedure

  1. Position the knock sensor and tighten the knock sensor bolt.
    Fig 1: View Of Right Knock Sensor & Bolt
    GM860801Courtesy of GENERAL MOTORS COMPANY
    CAUTION: Refer to Fastener Caution .

    Tighten 

    Tighten the bolt to 23 N.m (17 lb ft).

  2. Connect the engine wiring harness electrical connector (1) to the bank 1 knock sensor (2).
    Fig 2: Identifying Knock Sensor & Crankshaft Position (CKP) Sensor Electrical Connectors
    GM1860405Courtesy of GENERAL MOTORS COMPANY
  3. Install the exhaust manifold lower heat shield. Refer to Exhaust Manifold Lower Heat Shield Replacement .
scientia non olet · About LEMON Manuals