Front Parking Assist Alarm Sensor Bracket Replacement (Fascia)
Courtesy of GENERAL MOTORS COMPANY Front Parking Assist Alarm Sensor Bracket Replacement (Fascia)
| Callout |
Component Name |
Preliminary Procedures
Remove the front bumper fascia. Refer to . Front Bumper Fascia Replacement
Remove the advanced parking assist alarm sensor. Refer to Advance Parking Assist Alarm Sensor Replacement . |
| 1 |
Front Parking Assist Alarm Sensor Bracket Procedure
- Sand/grind sonic weld plastic residue from the fascia.
NOTE:
Do Not grind off alignment tabs.
- Clean Surface with Prepsol and wipe down with a clean towel.
- Spray on Loctite 770, (Polyolefin primer around surface), ensure full coverage of area to be glued.
- Apply structural adhesive epoxy, Loctite 435, to fascia at mating the surface.
- Using the alignment tabs or scribe line (where applicable), install the sensor bracket to the fascia.
- Apply pressure on the bracket for approximately 20 seconds.
- Allow adhesive to cure for 24 hours before moving the fascia.
|