Installation Procedure
- Position the lower control arm (1) in the cradle.
- Install and hand tighten the rear lower control arm bushing nuts and NEW bolts (1).
- Install and hand tighten the front lower control arm nut and NEW bolt (1).
- Support the lower control arm with a hydraulic jack and lift the control arm to p-Height. Refer to Trim Height Inspection .
- Tighten the NEW front lower control arm bolt (1) a first pass to 70 N.m (52 lb ft).
- Tighten the front lower control arm bolt (1) a final pass to an additional plus 75 to 90 degrees, using EN-45059 meter.
- Tighten the NEW rear bushing to frame bolts a first pass to 70 N.m (52 lb ft)
- Tighten the rear bushing to frame bolts a final pass to an additional plus 75 to 90 degrees, using EN-45059 meter.
- Remove the hydraulic jack.
- Install the NEW ball joint to knuckle bolt and nut and tighten a first pass to 30 N.m (22 lb ft).
- Tighten the ball joint to knuckle bolt and nut a final pass to an additional plus 60 to 75 degrees, using EN-45059 meter.
- Ensure that the ball joint boot (1) is properly seated between the lower control arm and the knuckle.
- Install the tire and wheel. Refer to Tire and Wheel Removal and Installation .
- Lower the vehicle.
CAUTION:
Refer to Fastener Caution .
WARNING:
Refer to Torque-to-Yield Fastener Warning .