LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2014 >> Impala Limited LTZ >> Repair and Diagnosis >> External Pages >> Different car >> Section 21 (Lighting System - Repair Instructions) >> Repair Instructions >> Brake Pedal Position Sensor Replacement

Brake Pedal Position Sensor Replacement

WARNING: This page is about a different car, the 2014 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Brake system does not use a brake switch, stoplight switch or brakelight switch. System uses a Brake Pedal Position Sensor to control these functions.
Fig 1: Brake Pedal Position Sensor
GM2209545Courtesy of GENERAL MOTORS COMPANY
Brake Pedal Position Sensor Replacement

Callout Component Name

Preliminary Procedure

  1. Remove the left side instrument panel insulator. Refer to Instrument Panel Insulator Replacement - Left Side .
  2. Disconnect the accelerator pedal position sensor electrical connector and position aside the wiring harness.
1 Brake Pedal Position Sensor Bolt
CAUTION:

Refer to Fastener Caution .
2 Brake Pedal Position Sensor

Procedure

  1. After the installation is complete, reposition the wiring harness and connect the electrical connector.
  2. After the installation is complete, calibrate the brake pedal position sensor. Refer to Brake Pedal Position Sensor Calibration .
scientia non olet · About LEMON Manuals