Removal Procedure
- Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
- Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
- Remove the front compartment splash shield. Refer to Front Compartment Splash Shield Replacement .
- Disconnect any harnesses or retainers secured to the front lower control arm. Note any attaching points to aid in installation.
- Remove the steering knuckle nut (1) and bolt (2). DISCARD the bolt.
- Separate the pinch joint at the front lower control arm ball joint and steering knuckle.
- Support the front lower control arm with a jackstand or other suitable tool.
- Remove the front lower control arm front nut (1) and bolt (2). DISCARD the bolt.
- Remove the front lower control arm rear nuts (1) and bolts (2). DISCARD the bolts.
- Remove the front lower control arm (3) from the vehicle.
- Transfer components as necessary.
CAUTION:
Do not pry against the ball joint boot when separating the ball joint from the steering knuckle. The integrated washer in the boot protects both the boot and joint and prying against the ball joint boot may damage the washer and impair the boot.
NOTE:
The steering knuckle is not shown for clarity only. It is not necessary to remove the steering knuckle to service the front lower control arm.
NOTE:
The steering knuckle is not shown for clarity only. It is not necessary to remove the steering knuckle to service the front lower control arm.