LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2014 >> Impala LS >> Repair and Diagnosis >> Electrical >> Charging Systems >> Battery, Charging System And Starting System >> Repair Instructions >> Starter Replacement (LFX) >> Installation Procedure

Installation Procedure

    Fig 1: Starter Motor And Bolts
    GM2201749Courtesy of GENERAL MOTORS COMPANY
  1. Position the starter motor (2) to the engine block.
    2. CAUTION:

    Refer to Fastener Caution .

  2. Install the starter motor mounting fasteners (1) and tighten to 58 (43 lb ft).
    3. Fig 2: View Of Starter Solenoid, Engine Harness Connector & Battery Positive Nut
    GM2196014Courtesy of GENERAL MOTORS COMPANY
  3. Install the battery positive cable and engine harness connector to the starter and tighten the battery positive cable fastener (1) to 9 (80 lb in).
  4. Install the engine harness connector to the starter solenoid.
  5. Connect the knock sensor connector.
    6. Fig 3: View Of Starter & Heat Shield
    GM2196015Courtesy of GENERAL MOTORS COMPANY
  6. Install the starter heat shield (2) and tighten the fastener (1) to 5 (44 lb in).
  7. Connect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection .
scientia non olet · About LEMON Manuals