LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2014 >> Impala LS >> Repair and Diagnosis >> Brakes >> Traction Control >> Antilock Brake System >> Repair Instructions >> Rear Wheel Speed Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING:

Refer to Brake Dust Warning .

  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the rear tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
  3. Remove the rear wheelhouse panel liner. Refer to Rear Wheelhouse Liner Replacement .
  4. Clean the wheel speed sensor mounting area on the suspension knuckle of any accumulated dirt and debris.
    5. Fig 1: Wheel Speed Sensor Harness Clips
    GM2867831Courtesy of GENERAL MOTORS COMPANY
  5. Release the wheel speed sensor harness clips (1) from the wheelhouse panel.
  6. Disconnect the wheel speed sensor harness electrical connector (2) and release the connector retainer from the bracket on the wheelhouse panel.
    7. Fig 2: Wheel Speed Sensor Harness Clips And Rear Suspension Bracket
    GM2330165Courtesy of GENERAL MOTORS COMPANY
  7. Release the wheel speed sensor harness clips (1) from the rear suspension bracket.
    8. Fig 3: Wheel Speed Sensor Bolt
    GM2330166Courtesy of GENERAL MOTORS COMPANY
  8. Remove the wheel speed sensor bolt (1).
  9. Remove the wheel speed sensor from the rear suspension knuckle.
scientia non olet · About LEMON Manuals