LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2014 >> Express 1500 LS, RWD >> Repair and Diagnosis >> Steering >> Power Steering System >> Repair Instructions >> Steering Gear Boot Replacement >> Removal Procedure

Removal Procedure

    Fig 1: Identifying Inner Tie Rod Assembly Jam Nut
    GM297360Courtesy of GENERAL MOTORS COMPANY
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the outer tie rod. Refer to Steering Linkage Outer Tie Rod Replacement .
  3. Remove the hexagon jam nut (2) from the inner tie rod (1).
    4. Fig 2: View Of Tie Rod End Clamp At Rack & Pinion Boot
    GM416130Courtesy of GENERAL MOTORS COMPANY
  4. Remove the tie rod end clamp (2) from the rack and pinion boot (1).
    5. Fig 3: View Of Boot Clamp And Rack & Pinion Boot
    GM416133Courtesy of GENERAL MOTORS COMPANY
  5. Remove the boot clamp (1) from the rack and pinion boot with side cutters.
  6. Discard the boot clamp (1).
    7. Fig 4: Identifying Rack & Pinion Boot & Breather Tube
    GM416160Courtesy of GENERAL MOTORS COMPANY
    IMPORTANT:
    • Prior to removing the breather tube or the rack and pinion boot, mark the location of the breather tube on the power steering gear.
    • After removing the boot, inspect the inner tie rod for evidence of corrosion or contamination. If none is evident, continue with the repair. If corrosion or contamination is evident, replace the steering gear.
  7. Disconnect the breather tube from the rack and pinion boot (1).

    Remove the rack and pinion boot (1) from the power steering gear.

scientia non olet · About LEMON Manuals