LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2014 >> Captiva Sport LS >> Repair and Diagnosis >> Brakes >> Traction Control >> Antilock Brake System >> Repair Instructions >> Brake Pressure Modulator Valve Bracket Replacement >> Removal Procedure

Removal Procedure

  1. Place the ignition switch in the OFF position.
  2. Remove the underhood electrical center. Refer to Underhood Electrical Center or Junction Block Replacement .
  3. Without draining the coolant or removing the hoses, remove and position aside the radiator surge tank. Refer to Radiator Surge Tank Replacement .
    4. Fig 1: BPMV Bolt
    GM1873930Courtesy of GENERAL MOTORS COMPANY
  4. Remove the brake pressure modulator valve (BPMV) bolt (1).
    5. Fig 2: BPMV Assembly
    GM1873931Courtesy of GENERAL MOTORS COMPANY
  5. Without disconnecting the brake pipe fittings, carefully lift the BPMV assembly (1) upward to release the mounting pins from the BPMV bracket insulators.

    Do not pry on the accumulator caps on the underside of the BPMV.

  6. Position the BPMV assembly aside and secure with heavy mechanics wire or equivalent.
    7. Fig 3: BPMV Bracket Bolts
    GM1873934Courtesy of GENERAL MOTORS COMPANY
  7. Remove the 2 BPMV bracket bolts (1).
    8. Fig 4: BPMV Bracket Nut
    GM1873935Courtesy of GENERAL MOTORS COMPANY
  8. Remove the BPMV bracket nut (1) and the BPMV bracket.
  9. Inspect the insulators for damage and replace, if necessary.
scientia non olet · About LEMON Manuals