LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2014 >> Camaro LS, Automatic Trans >> Repair and Diagnosis >> General Information >> OEM General Information >> Vehicle Diagnostic Information - Scan Tool Information - K20 ECM To Telematics >> Specifications Scan Tool Data >> Communication Interface Module Scan Tool Information

Communication Interface Module Scan Tool Information

Telematics Communication Interface Control Module Scan Tool Data Parameters

Parameter System State Expected Value Description
Operating Conditions:  Ignition ON
GPS Data 
  • Dead Reckoning Calibration Status
   Calibrated or Not Calibrated Indicates the dead reckoning calibration status.
  • Position Calibration Method
   Varies Indicates the method used to determine current location. (0) GPS, (1) Wheel Speed Dead Reckoning only, (2) Combined Wheel Speed and GPS, (3) Gyro only, (4) Combined Gyro and GPS, (5) No Fix
  • Month
   MM This displays the current month.
  • Day
   DD This displays the current day of the month.
  • Year
   YY This displays the current year.
  • Hour
   HH This displays the GPS current hour (24 hour format GMT).
  • Minute
   MM This displays the GPS current minute.
  • Second
   SS This displays the GPS current second.
  • GPS Signal
   Varies The scan tool displays Yes or No. Yes is displayed if there is a GPS signal received by the telematics communication interface control module.
Signal Strength Data 
  • Current Transceiver Identifier
   Varies The scan tool displays a 25 digit value. This is the transceiver identification number.
  • GSM Signal Strength
   Varies The scan tool displays 0127. This is the telematics communication interface control module signal strength.
  • Signal Type
   Digital This is the signal type received by the telematics communication interface control module.
Bluetooth Data 
  • Bluetooth
   Enabled Indicates if the Bluetooth system is enabled or disabled.
  • Bluetooth Link Status
   Varies Indicates the current link status. (0) Unconnected, (1) Connected/Idle, (2) Call active, (3) 3-way calling active
  • Bluetooth Link Quality
   Varies The scan tool displays a decimal value between 0 and 255.
  • Bluetooth Phone to Telematics Communication Interface Control Module Authentication Status
   Active or Inactive Displays the bluetooth phone to telematics communication interface control module authentication status.
  • Bluetooth Phone to Telematics Communication Interface Control Module Communication Status
   Active or Inactive Displays the bluetooth phone to telematics communication interface control module status.
  • Bluetooth Phone Voice Recognition Status
   Active or Inactive Displays the bluetooth phone to voice recognition status.
Telematics Communication Interface Control Module Scan Tool Output Controls

Output Control Description
B1000 Information This shows the data recorded when DTC B1000 was set in the telematics communication interface control module.
Green Indicator The telematics communication interface control module illuminates the green LED when ON is selected.
Phone Call Test When ON is selected, telematics communication interface control module commands OnStar to connect to the OnStar Center.
Red Indicator The telematics communication interface control module illuminates the red LED when ON is selected.
Preferred Roaming List Update The telematics communication interface control module performs a preferred roaming list (PRL) update when this is selected.
Remote Vehicle Speed Limiting Reset This function resets the speed limiting feature.
scientia non olet · About LEMON Manuals