Circuit/System Testing
- Ignition OFF, disconnect harness connectors X2 and X3 at the K41 Front and Rear Parking Assist Control Module, ignition ON.
- Test for less than 1 V between the 8 V reference circuit terminals listed below and ground.
- Terminal 4 X2
- Terminal 1 X3
- If 1 V or greater
Repair the short to voltage on the circuit.
- If less than 1 V
- Ignition OFF.
- Test for infinite resistance between 8V reference circuit terminals listed below and ground.
- Terminal 4 X2
- Terminal 1 X3
- If less than infinite resistance
Repair the short to ground on the circuit.
- If infinite resistance
- Replace the K41 Front and Rear Parking Assist Control Module.