LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2013 >> Traverse LS, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 53 (Disc Brake System) >> Repair Instructions >> Front Brake Caliper Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2010 Cadillac SRX. However, it is still accessible from the selected car via links, so may be relevant.
WARNING: Refer to Brake Dust Warning .
WARNING: Refer to Brake Fluid Irritant Warning .
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
    3. Fig 1: View Of Brake Hose Fitting Bolt
    GM2216181Courtesy of GENERAL MOTORS CORP.
  3. Remove the brake hose fitting bolt (1).
    4. NOTE: Do not reuse the brake hose fitting gaskets.
  4. Remove the 2 brake hose fitting gaskets (2) from the brake hose fitting (3) and discard the gaskets.
  5. Cap the brake hose fitting to prevent brake fluid loss and contamination.
    6. Fig 2: Identifying Caliper Guide Pins
    GM2216182Courtesy of GENERAL MOTORS CORP.
    NOTE:
    • DO NOT use any air tools to remove or install the guide pin bolts. Use hand tools ONLY.
    • Install an open end wrench to hold the caliper guide pin in line with the brake caliper while removing or installing the caliper guide pin bolt. DO NOT allow the open end wrench to come in contact with the brake caliper. Allowing the open end wrench to come in contact with the brake caliper will cause a pulsation when the brakes are applied.
  6. Using a backup wrench to hold the brake caliper guide pins stationary, remove the brake caliper guide pin bolts (1).
  7. Remove the brake caliper.
scientia non olet · About LEMON Manuals