LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2013 >> Traverse LS, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 335 (Power Steering System) >> Repair Instructions >> Power Steering Gear Outlet Pipe/Hose Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2016 GMC Acadia, 2016 Chevrolet Traverse, and 2016 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the power steering gear outlet hose to the vehicle.
    2. Fig 1: View Of Power Steering Gear Outlet Hose Bracket Bolt
    GM1870064Courtesy of GENERAL MOTORS COMPANY
  2. Position a new power steering gear outlet hose clamp (2).
  3. Connect the rubber segment to the metal segment of the power steering gear outlet hose (3, 4).
  4. Crimp the new power steering gear outlet hose crimp clamp.
    5. CAUTION:

    Refer to Fastener Caution .

  5. Install the power steering gear outlet hose bracket bolt (1) and tighten to 9 N.m (80 lb in).
    6. Fig 2: Identifying Power Steering Gear Inlet Hose Retaining Plate Bolt
    GM1861303Courtesy of GENERAL MOTORS COMPANY
  6. Insert the steering gear outlet hose in to the steering gear.
  7. Install the power steering gear inlet hose retaining plate bolt (1) and tighten to 9 N.m (80 lb in).
  8. Install the power steering gear inlet and outlet pipe clip bolt (2) and tighten to 9 N.m (80 lb in).
  9. Clean any excess fluid from the vehicle and remove the drain pans.
  10. Fill and bleed the power steering system. Refer to Power Steering System Bleeding .
scientia non olet · About LEMON Manuals