LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2013 >> Traverse LS, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 188 (Cellular System, Entertainment System, And Navigation System - Diagnostic Information And Procedures) >> Diagnostic Information and Procedures >> Eject Malfunction (without UWG) >> Circuit/System Testing

Circuit/System Testing

WARNING: This page is about a different car, the 2015 Cadillac SRX. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF and all vehicle systems OFF, disconnect the harness connector at the S48C Multifunction Switch 1- Instrument Panel. It may take up to 2 minutes for all vehicle systems to power down.
  2. Test for less than 10 Ω between the ground circuit terminal 9 and ground.
    • If 10 Ω or greater 
    1. Ignition OFF.
    2. Test for less than 2 Ω in the ground circuit end to end.
      • If 2 Ω or greater, repair the open/high resistance in the circuit.
      • If less than 2 Ω, repair the open/high resistance in the ground connection.
    • If less than 10 Ω 
  3. Verify a test lamp illuminates between the B+ circuit terminal 6 and ground.
    • If the test lamp does not illuminate 

      Repair the open/high resistance in the circuit.

    • If the test lamp illuminates 
  4. Ignition ON.
  5. Test for 2.5-3.5 V between the control circuit terminal 3 and ground.
    • If less than 2.5 V. 
    1. Ignition OFF, disconnect the X1 harness connector at the A33 Media Disc Player.
    2. Test for infinite resistance between the control circuit and ground.
      • If less than infinite resistance, repair the short to ground on the circuit.
      • If infinite resistance
    3. Test for less than 2 Ω in the control circuit end to end.
      • If 2 Ω or greater, repair the open/high resistance in the circuit.
      • If less than 2 Ω, replace the A33 Media Disc Player.
    • If greater than 3.5 V. 
    1. Ignition OFF, disconnect the X1 harness connector at the A33 Media Disc Player. Ignition ON.
    2. Test for less than 1 V between the control circuit and ground.
      • If 1 V or greater, repair the short to voltage the circuit.
      • If less than 1 V, replace the A33 Media Disc Player.
    • If 2.5-3.5 V. 
  6. Replace the S48C Multifunction Switch 1- Instrument Panel. Connect all harness connectors.
  7. Ignition ON, infotainment system ON. Insert a disc in the A33 Media Disc Player.
  8. Verify the disc ejects after touching the eject switch.
    • If the disc does not eject 

      Replace the A33 Media Disc Player.

    • If the disc ejects 
  9. All OK.
scientia non olet · About LEMON Manuals