LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2013 >> Traverse LS, AWD >> Repair and Diagnosis >> Body & Frame >> Seats >> Power Seat System >> Diagnostic Information and Procedures >> DTC B1335 >> Circuit/System Testing

Circuit/System Testing

B1335 00 or B1335 0B

  1. Ignition ON, use a scan tool to clear the current and history diagnostic trouble code.
  2. Determine which motor set this DTC by operating the motors listed below one at a time in both directions. Check for the DTC to set between each motor test.
    • Driver seat front vertical motor
    • Driver seat rear vertical motor
    • Driver seat horizontal motor
    • Driver seat recline motor
  3. Clear the diagnostic trouble codes.
  4. Ignition OFF, disconnect the harness connector at the appropriate seat motor for which the DTC set.
  5. Ignition ON, operate the motor adjuster switch in both directions. DTC B1335 00 or B1335 0B should not set.
    • If the DTC sets, test for a short between the motor control circuits. If the circuits test normal, replace the MSM.
  6. Test the control circuits for a high resistance. If the circuits test normal, test or replace the seat motor.

DTC B1335 42 or B1335 4B 

Verify that DTC B1335 42 or B1335 4B is not set.

scientia non olet · About LEMON Manuals