LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2013 >> Sonic RS, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 657 (Disc Brake System) >> Repair Instructions >> Front Brake Caliper Bracket Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2014 Chevrolet Sonic. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Brake Caliper Bracket
    GM1873956Courtesy of GENERAL MOTORS COMPANY
  1. Install the brake caliper bracket (1).
    2. Fig 2: Brake Caliper Bracket Bolts
    GM1873953Courtesy of GENERAL MOTORS COMPANY
    CAUTION: Refer to Fastener Caution .
  2. Install 2 new brake caliper bracket bolts (1) and tighten to 100 N.m (74 lb ft).
    3. Fig 3: Brake Pad Shims
    GM1873947Courtesy of GENERAL MOTORS COMPANY
  3. Install the brake pad springs (1).
    4. Fig 4: Upper And Lower Brake Caliper Guide Pins
    GM2375922Courtesy of GENERAL MOTORS COMPANY
  4. Install the 2 brake caliper guide pin seals.
  5. Ensure the brake caliper guide pin seals are fully seated in the groove of the brake caliper bracket.
  6. Install the upper brake caliper guide pin (1).
    NOTE: The upper brake caliper guide pin is equipped with a bushing and must be installed in the same location.
  7. Install the lower brake caliper guide pin (2).
  8. Ensure the brake caliper guide pin seals are fully seated in the groove of the brake caliper guide pins.
    9. Fig 5: Brake Pads
    GM2375921Courtesy of GENERAL MOTORS COMPANY
    NOTE: Note the location of the wear sensor for correct installation.
  9. Install the inner brake pad (1).
  10. Install the outer brake pad (2).
  11. Position the brake caliper over the brake pads and to the caliper bracket.
    12. Fig 6: Upper And Lower Brake Caliper Guide Pin Bolts
    GM2375920Courtesy of GENERAL MOTORS COMPANY
  12. Using a backup wrench to hold the brake caliper guide pin stationary, install the brake caliper guide pin bolts (1) and tighten to 28 N.m (21 lb ft).
  13. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
scientia non olet · About LEMON Manuals