LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2013 >> Impala LS >> Repair and Diagnosis >> External Pages >> Different car >> Section 216 (Rear Suspension System) >> Repair Instructions >> Spindle Rod Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2006 Chevrolet Monte Carlo and 2006 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  2. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
    Fig 1: View Of Spindle Rod And Rear Suspension Support Bolt
    GM614974Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Use a transmission jack or suitable hoist stands to prop the rear suspension support.
  3. Lower the rear suspension support to gain clearance to the spindle rod to knuckle bolt. Refer to Support Replacement .
  4. Remove the bolt (1) and nut from the spindle rod and the rear suspension support.
    5. Fig 2: View Of Spindle Rod, Knuckle, And Bolt
    GM803927Courtesy of GENERAL MOTORS CORP.
  5. Remove the spindle rod to knuckle bolt (4) and nut.
  6. Push the spindle rod to knuckle bolt (4) forward enough to provide clearance for the spindle rod (5) removal.
  7. Remove the spindle rod (5) from the vehicle.
scientia non olet · About LEMON Manuals