LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2013 >> Impala LS >> Repair and Diagnosis >> External Pages >> Different car >> Section 183 (Battery, Charging System And Starting System) >> Repair Instructions >> Battery Replacement (RPO LS4) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2006 Chevrolet Monte Carlo and 2006 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT: Do not tip the battery more than 40 degrees during installation.
    Fig 1: View Of Battery Retainer & Bolts
    GM1552777Courtesy of GENERAL MOTORS CORP.
  1. Install the battery.
    NOTE: Refer to Fastener Notice .
  2. Install the battery retainer (2) and bolts (1).

    Tighten:  Tighten the bolts to 18 N.m (13 lb ft).

    3. Fig 2: Identifying Negative Battery Cable Terminal & Battery
    GM1616995Courtesy of GENERAL MOTORS CORP.
  3. Install the positive battery cable terminal to the battery.
  4. Tighten the positive battery cable terminal nut.

    Tighten:  Tighten the nut to 15 N.m (11 lb ft).

  5. Position the positive battery cable terminal cover (2).
  6. Install the right front diagonal brace. Refer to Brace Replacement - Front Fender Upper Diagonal .
  7. Connect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure (RPOs LZE/LZ4/LZ9)  or Battery Negative Cable Disconnect/Connect Procedure (RPO LS4) .
scientia non olet · About LEMON Manuals