LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2013 >> Impala LS >> Repair and Diagnosis >> Electrical >> Charging Systems >> Battery, Charging System And Starting System >> Repair Instructions >> Starter Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Starter And Fasteners
    GM2632471Courtesy of GENERAL MOTORS COMPANY
    CAUTION:

    Refer to Fastener Caution .

  1. Position the starter (2), connect the engine harness connector and loosely install the top fastener (1).
  2. Install the bank 2 knock sensor. Refer to Knock Sensor Replacement - Bank 2 .
    3. Fig 2: Battery Positive Cable And Fastener
    GM2632474Courtesy of GENERAL MOTORS COMPANY
  3. Install the battery positive cable terminal (3) to the starter.
  4. Tighten the battery positive cable fastener (1) to 10 N.m (89 lb in).
  5. Raise the vehicle.
    6. Fig 3: Starter And Fasteners
    GM2632471Courtesy of GENERAL MOTORS COMPANY
  6. Install the lower starter fastener (1) and tighten to 58 N.m (43 lb ft).
  7. Lower the vehicle.
  8. Tighten the upper starter fastener (1) to 58 N.m (43 lb ft).
    9. Fig 4: Starter Heat Shield And Fastener
    GM2632479Courtesy of GENERAL MOTORS COMPANY
  9. Install the starter heat shield (2) and tighten the starter heat shield fastener (1) to 5 N.m (44 lb in).
  10. Install the engine coolant temperature sensor connector. Refer to Engine Coolant Temperature Sensor Replacement .
  11. Install the radiator air lower baffle and deflector. Refer to Radiator Air Lower Baffle and Deflector Replacement .
  12. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
scientia non olet · About LEMON Manuals