LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2013 >> Impala LS >> Repair and Diagnosis >> Electrical >> Charging Systems >> Battery, Charging System And Starting System >> Diagnostic Information and Procedures >> DTC B1516 >> Circuit/System Testing

Circuit/System Testing

B1516 08

  1. Ignition OFF, disconnect the harness connector at the battery current sensor.
  2. Ignition OFF, test for less than 5.0 ohms between the low reference circuit terminal B and ground.
    • If greater than specified range, test the low reference circuit for an open/high resistance. If the circuit tests normal, replace the BCM.
  3. Ignition ON, test for 4.8-5.2 volts between the battery current sensor supply voltage circuit terminal A and ground.
    • If less than the specified range , test the battery current sensor supply voltage circuit for a short to ground or an open/high resistance. If the circuit test normal, replace the BCM.
    • If greater than the specified range , test the battery current sensor supply voltage circuit for a short to voltage. If the circuit tests normal, replace the BCM.
  4. Ignition ON, test for 4.8-5.2 volts between the battery current sensor signal circuit terminal C and ground.
    • If less than the specified range, test the battery current sensor signal circuit for a short to ground or an open/high resistance. If the circuit test normal, replace the BCM.
    • If greater than the specified range, test the battery current sensor signal circuit for a short to voltage. If the circuit tests normal, replace the BCM.
  5. If all circuits test normal, replace the battery current sensor.

B1516 66 

When diagnosing B1516 66 verify that the battery current sensor is installed securely and positioned in the correct current flow direction.

scientia non olet · About LEMON Manuals