Installation Procedure
WARNING: This page is about a different car, the 2012 Chevrolet Captiva Sport. However, it is still accessible from the selected car via links, so may be relevant.
- Install the electronic parking brake control module (1) to the rear cover.
- Install the electronic parking brake control module bracket (1) to the electronic parking brake control module, if removed.
- Install the electronic parking brake control module bolts (1) and tighten the bolts to 9 N.m (80 lb in).
- Install the electronic parking brake control module and bracket assembly (1).
- Install the electronic parking brake control module bracket bolts (1) and tighten the bolts to 10 N.m (89 lb in).
- Connect the electronic parking brake control module electrical connector.
- Install the electronic parking brake control module front cover (1).
- Inspect the O-ring seals on the electronic parking brake control module spindle and the parking brake intermediate cable for damage and correct positioning and replace, if necessary.
- Install the parking brake intermediate cable fitting to the spindle.
- Connect the parking brake intermediate cable nut (1) to the electronic parking brake control module spindle by rotating the nut clockwise and tighten to 6 N.m (53 lb in).
- Enable the parking brake cable adjuster. Refer to Parking Brake Cable Adjuster Enabling .
CAUTION:
Refer to Fastener Caution .
NOTE:
Ensure the park brake intermediate cable fitting is engaged in the actuator in the spindle.
NOTE:
When installing the parking brake intermediate cable nut to the electronic park brake module spindle, hold the spindle housing securely to avoid distorting the housing.