LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2013 >> Camaro LS, Automatic Trans >> Repair and Diagnosis >> Restraints >> Air Bag, SRS >> Supplemental Inflatable Restraint System >> Repair Instructions >> Airbag Roof Side Rail Module Replacement

Airbag Roof Side Rail Module Replacement

Fig 1: Roof Side Rail Inflatable Restraint Module And Fasteners
GM2210881Courtesy of GENERAL MOTORS COMPANY
Airbag Roof Side Rail Module Replacement

Callout Component Name
WARNING:

In order to prevent SIR deployment, personal injury, or unnecessary SIR system repairs, do not strike the door or the door pillar in the area of the side impact sensor (SIS). Turn OFF the ignition and remove the key when performing service in the area of the SIS.

WARNING:

When installing the roof rail airbag, do not twist or turn the airbag 360 degrees. Securing the roof rail airbag with an airbag twisted or turned 360 degrees may cause the airbag not to deploy correctly and could cause personal injury.

WARNING:

Refer to SIR Warning .

Preliminary Procedures

  1. Disable the SIR system. Refer to SIR Disabling and Enabling .
  2. Lower the side of the headliner. Refer to Headlining Trim Panel Replacement (Coupe) .
  3. Lower the side of the headliner, if equipped. Refer to Sunroof Panel Trim Panel Replacement (Coupe) .
1 Roof Side Rail Inflatable Restraint Module Fastener (Qty: 8)
CAUTION:

Refer to Fastener Caution .


Tighten 
9 N.m (80 lb in)
2 Inflatable Restraint Roof Side Rail Module Assembly

Procedure

  1. Disconnect the electrical connector.
  2. Release the integral clips.
  3. Remove the roof side rail inflatable restraint module from the vehicle.
  4. Refer to Inflatable Restraint Module Handling and Scrapping (Europe) , Inflatable Restraint Module Handling and Scrapping (Except Europe) .