LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Volt >> Repair and Diagnosis >> Engine Performance >> System >> Data Communications System - DTC B1000 To DTC U183E >> Diagnostic Information and Procedures >> DTC P16B7 >> Circuit/System Testing

Circuit/System Testing

    NOTE:

    Use the schematic to identify the control modules B+, ignition, ground, communication enable and serial data circuit terminals.

  1. Vehicle OFF, disconnect the X1 harness connector at the G1 A/C compressor.
  2. Vehicle in Service Mode, verify that a test lamp illuminates between the wake up circuit terminal 2 X1 and ground.
    • If the test lamp does not illuminate, test the circuit for a short to ground or open/high resistance. If the circuit tests normal, replace the K114B hybrid powertrain control module 2.
  3. Vehicle OFF, verify that a test lamp does not illuminate between the wake up circuit terminal 2 X1 and ground.
    • If the test lamp illuminates, test the circuit for a short to voltage. If the circuit tests normal, replace the K114B hybrid powertrain control module 2.
  4. If all circuits test normal, replace the G1 A/C compressor.
scientia non olet · About LEMON Manuals