LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Volt >> Repair and Diagnosis >> Brakes >> Parking Brake System >> Repair Instructions >> Electronic Parking Brake Control Module Replacement >> Removal Procedure

Removal Procedure

  1. Place the transmission in PARK.
  2. Disable the parking brake cable adjuster. Refer to Parking Brake Cable Adjuster Disabling .
  3. Place the power button in the OFF position.
    4. WARNING:

    Do not use a service jack in locations other than those specified to lift this vehicle. Lifting the vehicle with a jack in those other locations could cause the vehicle to slip off the jack and roll; this could cause injury or death.

  4. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  5. Remove the left rear tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
  6. Remove the left rear wheelhouse panel liner. Refer to Rear Wheelhouse Panel Liner Replacement .
    7. Fig 1: Parking Brake Cable And Nut
    GM2391020Courtesy of GENERAL MOTORS COMPANY
  7. Remove the parking brake cable nut (1) from the electronic parking brake control module.
  8. Disconnect the electronic parking brake control module electrical connector.
    9. Fig 2: Electronic Parking Brake Control Module And Nuts
    GM2391024Courtesy of GENERAL MOTORS COMPANY
  9. Remove the electronic parking brake control module nuts (1).
    10. Fig 3: Electronic Parking Brake Control Module
    GM2391027Courtesy of GENERAL MOTORS COMPANY
  10. Lower the front of the electronic parking brake control module (1) and release the module from the grommet in the vehicle body.
  11. Remove the electronic parking brake control module.
scientia non olet · About LEMON Manuals