LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Traverse LS, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 362 (Antilock Brake System) >> Repair Instructions >> Rear Wheel Speed Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2016 GMC Acadia, 2016 Chevrolet Traverse, and 2016 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Wheel Speed Sensor Electrical Connector
    GM1861964Courtesy of GENERAL MOTORS COMPANY
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
  3. Disconnect the wheel speed sensor electrical connector (1).
  4. Release the wheel speed sensor wire harness grommet (2) from the lower control arm bracket.
  5. Release the wheel speed sensor wire harness routing clips (3) from the upper suspension link.
    6. Fig 2: Wheel Speed Sensor Bolt
    GM1861969Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    Clean the wheel speed sensor mounting area on the wheel knuckle of any accumulated dirt and debris.

  6. Remove the wheel speed sensor bolt.
  7. Pull the wheel speed sensor straight up and out of the wheel knuckle.
scientia non olet · About LEMON Manuals