Steering Knuckle Replacement

WARNING: This page is about a different car, the 2013 GMC Acadia, 2013 Chevrolet Traverse, and 2013 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Steering Knuckle

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedures Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle . Remove the wheel bearing/hub assembly. Refer to Front Wheel Bearing and Hub Replacement . Disconnect the outer tie rod from the steering knuckle. Refer to Steering Linkage Outer Tie Rod Replacement . Disconnect the lower ball joint from the steering knuckle. Refer to Lower Control Arm Ball Joint Replacement .
1	Front Strut Suspension Nut (Qty: 2)
2	Front Strut Suspension Bolt (Qty: 2) CAUTION: Refer to Fastener Caution . TIP: Support the wheel drive shaft with mechanics wire after the knuckle has been removed. Tighten 195 N.m (144 lb ft)
3	Steering Knuckle