LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Traverse LS, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 165 (Front Suspension System) >> Repair Instructions >> Lower Control Arm Ball Joint Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2013 GMC Acadia, 2013 Chevrolet Traverse, and 2013 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the lower control arm assembly. Refer to Lower Control Arm Replacement .
  2. Install the lower control arm in a vise.
    3. Fig 1: Drilling Off Head Of Rivet
    GM1853593Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    Use a center punch to aid in starting the drill if drilling the rivet.

  3. Drill or grind off the head of the rivet.
    4. Fig 2: Removing Rivets With Punch And Hammer
    GM1853591Courtesy of GENERAL MOTORS COMPANY
  4. Use a punch and a hammer to loosen the rivets from the lower control arm.
    5. Fig 3: Lower Control Arm Rivets
    GM1853594Courtesy of GENERAL MOTORS COMPANY
  5. Remove the rivets from the lower control arm.
    6. Fig 4: Ball Joint At Lower Control Arm
    GM1853595Courtesy of GENERAL MOTORS COMPANY
  6. Enlarge the hole for the ball joint bolt to 31/64.
  7. Remove the ball joint from the lower control arm.
scientia non olet · About LEMON Manuals