LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Orlando LS, Standard Trans >> Repair and Diagnosis >> Suspension >> Front Suspension >> Front Suspension System >> Repair Instructions >> Wheel Stud Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Identifying Bearing/Hub Assembly
    GM2027808Courtesy of GENERAL MOTORS COMPANY
  1. Install a NEW stud into the bearing/hub assembly (2). Add enough washers (3) in order to draw the stud into the hub.
  2. Install and tighten a wheel nut (1) until the head of the wheel stud is fully seated against the back of the bearing/hub flange (2).
  3. Remove the wheel nut (1) and the washers (3).
  4. Install the brake rotor, and install the brake caliper and bracket as an assembly. Refer to Front Brake Rotor Replacement .
  5. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
  6. Lower the vehicle.
scientia non olet · About LEMON Manuals