LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Orlando LS, Standard Trans >> Repair and Diagnosis >> Restraints >> Air Bag, SRS >> Supplemental Inflatable Restraint System >> Repair Instructions >> Inflatable Restraint Side Impact Sensor Replacement

Inflatable Restraint Side Impact Sensor Replacement

Fig 1: Inflatable Restraint Side Impact Sensor And Screw
GM2027731Courtesy of GENERAL MOTORS COMPANY
Inflatable Restraint Side Impact Sensor Replacement

Callout Component Name
WARNING:

Refer to SIR Warning .

WARNING:

Refer to SIR Inflator Module Handling and Storage Warning .

WARNING:

Following the deployment of a side impact air bag, inspect the following parts for damage. Replace these parts if necessary:

  • The seat cushion frame
  • The seat recliner, if equipped
  • The seat adjuster
  • The seat back frame

Failure to do so may cause future personal injury.

Preliminary Procedures

  1. Disable the SIR system. Refer to SIR Disabling and Enabling .
  2. Remove the center pillar lower garnish molding. Refer to Center Pillar Lower Garnish Molding Replacement .
1 Inflatable Restraint Side Impact Sensor Screw
CAUTION:

Refer to Fastener Caution .


Tighten 
7.5 N.m (66 lb in)
2 Inflatable Restraint Side Impact Sensor

Procedure

  1. Disconnect electrical connector.
  2. Loosen the bolts and slide the sensor out of the keyhole slots.

TIP:  The bolt is integral to the sensor assembly, DO NOT remove separately.
scientia non olet · About LEMON Manuals