Front End Inflatable Restraint Discriminating Sensor Replacement

Fig 1: Inflatable Restraint Front End Sensor And Bolt

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
WARNING: Refer to SIR Warning . WARNING: Following the deployment of a side impact air bag, inspect the following parts for damage. Replace these parts if necessary: The seat cushion frame The seat recliner, if equipped The seat adjuster The seat back frame Failure to do so may cause future personal injury. Preliminary Procedures Disable the SIR system. Refer to SIR Disabling and Enabling .
1	Inflatable Restraint Front End Sensor Bolt CAUTION: Refer to Fastener Caution . Tighten 7.5 N.m (66 lb in)
2	Inflatable Restraint Front End Sensor Procedure Disconnect electrical connector. Loosen the bolt and slide the sensor out of the keyhole slot. TIP: The bolt is integral to the sensor assembly, DO NOT remove separately.

Callout

Component Name

WARNING:

WARNING:

Following the deployment of a side impact air bag, inspect the following parts for damage. Replace these parts if necessary:

Failure to do so may cause future personal injury.

Preliminary Procedures Disable the SIR system. Refer to SIR Disabling and Enabling .

Inflatable Restraint Front End Sensor Bolt

CAUTION:

Tighten
7.5 N.m (66 lb in)

Inflatable Restraint Front End Sensor

Procedure

TIP: The bolt is integral to the sensor assembly, DO NOT remove separately.