LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Orlando LS, Standard Trans >> Repair and Diagnosis >> Electrical >> Charging Systems >> Battery, Charging System And Starting System >> Repair Instructions >> Battery Replacement (Gasoline) >> Removal Procedure

Removal Procedure

  1. Disconnect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection (without Start/Stop System) .
  2. Fig 1: Battery Fuse Box Cover
    GM2577153Courtesy of GENERAL MOTORS COMPANY
  3. Unlock the retaining tab (1) on the battery fuse box cover.
  4. Use a suitable screwdriver (2) to unlock the clip (4) through the window (3).
  5. NOTE:

    Pull the battery box housing, not the flap.

  6. Open the battery fuse box cover.
  7. Fig 2: Starter Cable, Battery Positive Cable And Retainer
    GM2372588Courtesy of GENERAL MOTORS COMPANY
  8. Remove the battery hold down retainer nut (5).
  9. Remove the battery hold down retainer (6).
  10. Remove the battery positive cable to starter cable nut (1).
  11. Remove the battery positive cable to starter cable (7).
  12. Loosen the 2 battery positive plate nuts (2).
  13. Loosen the battery positive cable nut (3).
  14. Remove the battery positive cable (4).
  15. Fig 3: Fuse Block Retainer Clips
    GM2191743Courtesy of GENERAL MOTORS COMPANY
  16. Unclip the battery fuse block retainer clips (1) from the battery and remove the battery fuse block along with the battery positive cable.
  17. Fig 4: Battery Tray Protector And Battery Tray Protector Retainer
    GM2191744Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    Only necessary if vehicle is equipped with a short battery.

  18. Unclip the battery tray protector retainer (2) from battery tray.
  19. Remove the battery tray protector (1) by moving in direction of the arrow.
  20. Fig 5: Battery Position
    GM2191745Courtesy of GENERAL MOTORS COMPANY
  21. Move the battery (1) in direction of the arrow and remove it with GE-49379  remover.