LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Impala LS, Gas >> Repair and Diagnosis >> External Pages >> Different car >> Section 1218 (Hydraulic Brake System) >> Repair Instructions >> Brake Pedal Assembly Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2010 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of 3 Brake Pedal Assembly-To-Instrument Panel (I/P) Carrier Bolts
    GM1242219Courtesy of GENERAL MOTORS CORP.
  1. Install the brake pedal assembly to the vehicle.
    2. CAUTION: Refer to Fastener Caution .
  2. Install the 3 brake pedal assembly to I/P carrier bolts and tighten to 25 N.m (18 lb ft).
    3. Fig 2: View Of 2 Brake Pedal Assembly To Cowl Mounting Nuts
    GM1241592Courtesy of GENERAL MOTORS CORP.
  3. Install the 2 brake pedal assembly to cowl mounting nuts and tighten to 15 N.m (11 lb ft).
    4. Fig 3: View Of Booster Pushrod Retaining Clip, Washers & Booster Pushrod
    GM1301945Courtesy of GENERAL MOTORS CORP.
  4. Connect the brake pedal pushrod retaining clip (1) the wave washers (2) and the brake booster pushrod (3) to the brake pedal pin (4).
  5. Install the steering column assembly to the vehicle. Refer to Steering Column Replacement (Electronic Power Steering) or Steering Column Replacement (Hydraulic Power Steering) .
  6. Connect the electrical connector to the brake apply sensor.
  7. Install the left side instrument panel insulator panel. Refer to Instrument Panel Insulator Replacement - Left Side .
  8. Install the knee bolster. Refer to Driver Knee Bolster Panel Replacement .
  9. Calibrate the brake pedal position sensor. Refer to Brake Pedal Position Sensor Calibration .
scientia non olet · About LEMON Manuals