Installation Procedure
WARNING: This page is about a different car, the 2011 Chevrolet Cruze. However, it is still accessible from the selected car via links, so may be relevant.
- Install the upper spring seat/jounce bumper (1) on the spring.
- Install the spring (1) making sure the lower coil is seated into the lower spring seat.
- Using the jack stands, raise the rear axle in order to compress the rear springs.
- Install the lower shock absorber bolts. Refer to Shock Absorber Replacement .
- Lower the vehicle.
NOTE:
If the spring is equipped with tags, ensure that the tags are at the upper rear portion of the spring. If marks were made during removal, ensure the marks are properly aligned.