LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Corvette Z06 >> Repair and Diagnosis >> Steering >> Steering Wheel And Steering Column >> Diagnostic Information and Procedures >> DTC B2860 >> Circuit/System Testing

Circuit/System Testing

  1. Ignition OFF, disconnect the harness connector at the telescoping drive motor.
  2. Ignition OFF, test for less than 1.0 ohm resistance between the low reference circuit terminal E and ground
    • If greater than the specified range, test the low reference circuit for open/high resistance. If the circuit tests normal, replace the memory seat module - driver
  3. Ignition ON, test for 4.8-5.2 volts between the 5-volt reference circuit terminal D and ground.
    • If less than the specified range, test the 5-volt reference circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the memory seat module - driver
    • If greater than the specified range, test the 5-volt reference circuit for a short to voltage. If the circuit tests normal, replace the memory seat module - driver
  4. Verify the scan tool Telescope Sensor parameter is greater than 4.75 volts.
    • If less than the specified range, test the signal circuit terminal C for a short to ground. If the circuit tests normal, replace the memory seat module - driver.
  5. Install a 3A fused jumper wire between the signal circuit terminal C and the low reference circuit terminal A. Verify the scan tool Telescope Sensor parameter is less than 0.25 volt.
    • If greater than the specified range, test the signal circuit for a short to voltage or an open/high resistance. If the circuit tests normal, replace the memory seat module - driver.
  6. If all circuits tests normal, test or replace the telescoping drive motor.
scientia non olet · About LEMON Manuals