LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Corvette Base, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> Body & Frame >> Fixed And MOVEABLE Windows >> Repair Instructions >> Door Window Regulator Replacement >> Removal Procedure

Removal Procedure

WARNING:

Refer to Express Down Feature Warning .

NOTE:

The regulator and the motor are serviced as an assembly.

    Fig 1: View Of Door Trim Panel
    GM63818Courtesy of GENERAL MOTORS COMPANY
  1. Remove the door trim panel. Refer to Front Side Door Trim Panel Replacement - Left Side , or Front Side Door Trim Panel Replacement - Right Side .
  2. Remove the water deflector.
    3. Fig 2: Radio Speaker Assembly At Door
    GM63833Courtesy of GENERAL MOTORS COMPANY
  3. Remove the radio speaker assembly from the door.
    1. Disconnect the electrical/audio connector.
    2. Remove the speaker retaining screws.
    4. Fig 3: View of Window Clamp Access Plugs
    GM63834Courtesy of GENERAL MOTORS COMPANY
  4. Remove the plugs from the window clamp sight access holes.
    5. Fig 4: View Of Door Window
    GM63801Courtesy of GENERAL MOTORS COMPANY
  5. Remove the door window. Refer to Door Window Replacement .
    6. Fig 5: Regulator Motor Electrical Connector
    GM63808Courtesy of GENERAL MOTORS COMPANY
  6. Disconnect the regulator motor electrical connector.
    7. Fig 6: View Of Large Access Plug
    GM63803Courtesy of GENERAL MOTORS COMPANY
  7. Remove the front plug from under the bottom of the door.
    8. Fig 7: View of Regulator Studs & Nuts
    GM63807Courtesy of GENERAL MOTORS COMPANY
  8. Mark the location of the regulator to aid in reassembly.
  9. Remove the nuts from the regulator lower channel studs.
  10. Remove the nuts from the regulator motor studs.
  11. Remove the regulator rose bud clip from the door.
  12. Remove the nuts from the upper regulator channel studs.
  13. Fold the regulator and remove the regulator through the door inner opening.
scientia non olet · About LEMON Manuals