LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Caprice 6.0 2 >> Repair and Diagnosis >> External Pages >> Different car >> Section 162 (Programming And Setup - All Systems) >> Repair Instructions >> Instrument Cluster Programming and Setup >> Instrument Cluster Replacement and/or Reprogramming

Instrument Cluster Replacement and/or Reprogramming

WARNING: This page is about a different car, the 2011 Chevrolet Caprice. However, it is still accessible from the selected car via links, so may be relevant.

If the instrument cluster needs to be replaced and/or reprogrammed, the following procedures must be performed:

  1. Connect a scan tool to the vehicle and access SPS. Refer to Service Programming System (SPS) .
    2. NOTE:

    The Prepare Control Module for Removal function can only be performed when communication with the old control module is still possible.

  2. Before removing the old instrument cluster, perform the SPS function Prepare Control Module for Removal.
  3. Replace the instrument cluster.
  4. Perform the SPS function Instrument Cluster - Programming and follow the on-screen instructions.
  5. Perform the SPS function Instrument Cluster - Configuration and follow the on-screen instructions.
  6. Perform the SPS function Instrument Cluster - Setup and follow the on-screen instructions.
  7. Clear DTCs after completing the programming procedure.
scientia non olet · About LEMON Manuals