LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Caprice 3.6 3 >> Repair and Diagnosis >> Suspension >> Front Suspension >> Front Suspension System >> Repair Instructions >> Strut Assembly Removal and Installation >> Installation Procedure

Installation Procedure

    Fig 1: Front Suspension Strut
    GM2195888Courtesy of GENERAL MOTORS COMPANY
  1. Position the front suspension strut (1) in the vehicle.
  2. Fig 2: Mark On Steering Knuckle & Strut Assembly
    GM2195609Courtesy of GENERAL MOTORS COMPANY
  3. Align the front suspension strut (1) with the alignment mark (2).
  4. Fig 3: Front Strut Nuts & Bolts
    GM2195813Courtesy of GENERAL MOTORS COMPANY
  5. Install the front suspension strut bolts (2).
  6. Install the front suspension strut nuts (1) and tighten. DO NOT torque to specifications at this time.
  7. Fig 4: Front Suspension Nut & Washer
    GM2195831Courtesy of GENERAL MOTORS COMPANY
  8. Install the front suspension strut mount washer (2) and front suspension strut nut (1).
  9. Fig 5: Special Tool And Torx(R) Bit
    GM2424066Courtesy of GENERAL MOTORS COMPANY
  10. Using the J 35669  wrench (2) and a Torx® bit (1), tighten the front suspension strut nut and tighten to 55 N.m (41 lb ft).
  11. Remove the hydraulic floor jack.
  12. Install the front suspension strut nut cap, if equipped.
  13. Install the front stabilizer shaft link. Refer to Stabilizer Shaft Link Replacement .
  14. Install the wheel speed sensor. Refer to Front Wheel Speed Sensor Replacement .
  15. Install the front brake hose. Refer to Front Brake Hose Replacement .
  16. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
  17. Lower the vehicle.
  18. Check and adjust the front wheel alignment, if needed. Refer to Front Caster and Camber Adjustment .
  19. CAUTION:

    Refer to Fastener Caution .

  20. Using the EN 45059  kit and a torque wrench, tighten the front strut nuts to:
    • First Pass: 80 N.m (59 lb ft)
    • Final Pass: plus 180 degrees