LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Caprice 3.6 3 >> Repair and Diagnosis >> Suspension >> Front Suspension >> Front Suspension System >> Repair Instructions >> Steering Knuckle Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Steering Knuckle Assembly And Strut
    GM2193010Courtesy of GENERAL MOTORS COMPANY
  1. Position the steering knuckle (2) in the front suspension strut (1).
    2. Fig 2: Front Suspension Strut Bolts & Nuts
    GM2193011Courtesy of GENERAL MOTORS COMPANY
  2. Install the front suspension strut bolts (2) and nuts (1).
    3. Fig 3: Mark On Steering Knuckle & Strut Assembly
    GM2195609Courtesy of GENERAL MOTORS COMPANY
  3. Align the reference mark (2) on the steering knuckle (3) and the front suspension strut (1).
    4. Fig 4: Front Suspension Strut Bolts & Nuts
    GM2193011Courtesy of GENERAL MOTORS COMPANY
    CAUTION:

    Refer to Fastener Caution .

  4. Install the front suspension strut bolts (2) and nuts (1) and tighten to 80 N.m (59 lb ft) plus an additional 180 degrees.
  5. Install the front lower control arm. Refer to Front Lower Control Front Arm Replacement .
  6. Install the front lower control rear arm. Refer to Control Arm Replacement .
  7. Install the outer tie rod end. Refer to Steering Linkage Outer Tie Rod Replacement .
  8. Install the front wheel bearing. Refer to Front Wheel Bearing and Hub Replacement .
  9. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
  10. Install the speed sensor. Refer to Front Wheel Speed Sensor Replacement .
  11. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
  12. Remove the support and lower the vehicle.
  13. Check and adjust the front wheel alignment, if needed. Refer to Front Caster and Camber Adjustment .
scientia non olet · About LEMON Manuals