Installation Procedure
WARNING: This page is about a different variant/trim than selected.
- Install the accelerator pedal to the steering column support bracket.
- Install the accelerator pedal to steering column support bracket retaining bolts (2) and tighten to 9 N.m (80 lb in).
- Connect the accelerator pedal sensor module electrical connector (1).
- Inspect for correct carpet fit under the accelerator pedal.
- If re-programming is required, refer to Control Module References .
- Install the left I/P on the lower closeout insulator panel. Refer to Knee Bolster Replacement .
CAUTION:
Refer to Fastener Caution .