LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Camaro ZL1, Standard Trans >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine Controls/Fuel - 6.2L - Repair Instructions >> Repair Instructions >> Fuel Tank Filler Pipe Replacement >> Removal Procedure

Removal Procedure

  1. Remove the fuel filler cap.
    2. WARNING:

    To avoid any vehicle damage, serious personal injury or death when major components are removed from the vehicle and the vehicle is supported by a hoist, support the vehicle with jack stands at the opposite end from which the components are being removed and strap the vehicle to the hoist.

    WARNING:

    Refer to Safety Glasses Warning .

  2. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  3. Drain the fuel tank below the level of the fuel filler hose. Refer to Fuel Tank Draining .
  4. Remove the right rear wheel. Refer to Tire and Wheel Removal and Installation (w RT2) , Tire and Wheel Removal and Installation (w/o RT2) .
  5. Remove the right rear wheelhouse liner. Refer to Rear Wheelhouse Panel Liner Replacement .
  6. Remove the rear bumper fascia. Refer to Rear Bumper Fascia Replacement .
    7. Fig 1: View Of Quick Connect Fitting, EVAP Line, Fuel Filler Tube & Hose With Clamp
    GM2121477Courtesy of GENERAL MOTORS COMPANY
  7. Remove the filler tube to chassis retaining bolts (6).
  8. Disconnect the evaporative emission (EVAP) line (2) from the quick connect fitting (1). Refer to Plastic Collar Quick Connect Fitting Service .
  9. Remove the retaining hose clamp (4).
  10. Disconnect the fuel filler tube (3) from the fuel filler hose (5).
  11. Maneuver the fuel filler tube (7) and remove from the vehicle.
scientia non olet · About LEMON Manuals