LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Camaro ZL1, Automatic Trans >> Repair and Diagnosis >> Steering >> Power Steering System >> Diagnostic Information and Procedures >> DTC C0460 >> Circuit/System Testing

Circuit/System Testing

  1. Ignition ON, verify that DTC C0710 is not present.
    • If the DTC is present with any symptom byte, refer to DTC C0710 .
  2. Inspect the B99 Steering Wheel Angle Sensor for correct installation.
  3. Ignition OFF, disconnect the harness connector at the B99 Steering Wheel Angle Sensor.
  4. Test for less than 5 Ω between the ground circuit terminal 6 and ground.
    • If greater than the specified value, test the ground circuit for an open/high resistance.
  5. Ignition ON, test for greater than 11 V between the 12 V reference circuit terminal 5 and ground.
    • If less than the specified range, test the 12 V reference circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the K17 Electronic Brake Control Module.
  6. If all circuits test normal, replace the B99 Steering Wheel Angle Sensor and verify the DTC does not reset.
    • If the DTC resets, replace the K17 Electronic Brake Control Module.
scientia non olet · About LEMON Manuals